Image path is broken
This chip contains an opcode decoder, 8-bit ALU, 7 general purpose and 3 special purpose 6-bit registers, branch target selector, and other supporting structures all connected together to make a 1-stage microprocessor
To put the processor in a valid state, hold the reset pin high for one clock cycle. Instructions can begin to be fed into the processor at the beginning of the next cycle when reset is set low. When the clock signal is high, the PC will be output. When the clock signal is low, the x8 register will be output. There are example programs in the testbench folder and a more thourough explaination in the project readme.
| # | Input | Output |
|---|---|---|
| 0 | clk | out0 |
| 1 | reset | out1 |
| 2 | in0 | out2 |
| 3 | in1 | out3 |
| 4 | in2 | out4 |
| 5 | in3 | out5 |
| 6 | in4 | out6 |
| 7 | in5 | out7 |